This page contains a Flash digital edition of a book.
GROUND RULES by cl i ff jacobson The Cutting Edge Tips for sharpening your favorite blade—safely and effectively.


on diamond stones—to float away steel particles that clog the pores of the stone and reduce its cutting efficiency. Do not use automo- tive or gun oils. After every few dozen strokes, dry the stone and blade and apply new oil. You’ll go through a lot of oil this way, but you won’t dull the edge by grinding metal particles into it. Frequent cleaning is essential if you want a super-sharp edge.


fSharpening will go easier if you dip the cold blade into boiling water for a few seconds before beginning to sharpen it.


AT SUMMER CAMP, your Scouts are doing a pioneering project. They’re proud of their smooth, tight lashings. A boy tries to cut a length of cord, sawing at it without success. Smiling, you hand him your knife and say, “Try this!” In a flash, the cord is cut. The boy looks at you with wondering eyes and says, “How’d ya get it so sharp?” It’s easy to sharpen a knife. All you


need is a whetstone and practice. The method described here works with any nonserrated blade.


First, Some Rules fElectric and mechanical sharpen- ers produce an acceptable working


40 S COUTING ¿ NOVEMBER•DECEMBER 2011


edge but not a wickedly sharp one. Instead, use a whetstone.


fDon’t use a grindstone on a knife; it will destroy the edge and the temper.


fIf you have a dull knife, begin sharpening with a coarse-grit, natural (carborundum, aluminum oxide, Washita), or diamond stone. Change to a medium-grit stone when the nicks are gone and the edge is smooth. If you keep your knife reasonably sharp, all you’ll need is a medium-grit stone.


fMaintain a thin film of cutting oil, kerosene, or WD-40 (my prefer- ence) on natural stones—or water


Sharpening Procedure Keep the back of the blade raised about 15 degrees and cut into the stone (see the chalkboard sketch at left). If you have an official Boy Scout or Swiss Army knife, you can approxi- mate the correct angle if you rest the back edge of the blade on two stacked pennies. Another trick is to set the blade flat on the stone and adjust a bright light directly overhead. Slowly raise the back of the blade until you can just see a shadow. You can even buy special tools that clamp to a knife blade and maintain the recommended sharpening angle. These tools work well on the body of the blade but not on a sharply curved tip. Learn to hold the right angle by hand (it just takes practice), and you’ll never need a clamp. Take about six strokes on one side


of the stone, then turn the blade over and repeat the process. Keep the stone lubricated with honing fluid. If you want a razor’s edge, switch to a fine- grit stone (natural or diamond).


YUTA ONODA


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60